Viewing 1 post (of 1 total)
  • Author
  • #5045
    Martin Innes
    Forum Participant

    We’re working on a Philco 3118 floor model, after getting it up and working , the voltage looks pretty high on the B+, about 330v were the schematic I have lists the B+ as 280. The filament voltage is 6.3. The input is listed as 115v, 20/40 cycles. My local line voltage runs about 125v. What would be suggested, dropping resistor in the B+ line? Also wondering if anyone has a similar unit to know what the correct control knobs look like. Any info would be appreciated..

    Thanks Martin…………….

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.