- This topic has 4 replies, 2 voices, and was last updated 9 years, 6 months ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
-
…found what i thought were the same knobs, but the “D” in the shaft sleeve was the wrong size. the measurements i need are as follows:
26mm or 1”- DIAMETER
24mm or 7/8”- LENGTH OF SHAFT SLEEVE
For the “D” hole in the shaft sleeve, it measures 4.3 mm or roughly 11/64 from flat part of hole to top of arc, the length of the base in the “D” hole is 6.8 mm or roughly 17/64”.
any help would be appreciated!
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.