Home › Forums › Electronics Restoration › 2X3 Tubes

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • May 19, 2013 at 2:13 pm #4318
    Ed Kraushar
    CVRS Member

    I had the impression that 2X3 rectifier tubes for Rogers radios were scarce. Silly me. I have had two NIB ones on Ebay for a week with no bids and only two watchers. The auction is over, and not to be re-listed.

    Ed.

    May 25, 2013 at 10:09 am #4328
    Bob Masse
    Forum Participant

    Ed,
    Apparently they are looking for a particular brand. I would have bid on yours but I’ve been so busy lately I haven’t checked the eBay listings.
    Bob Masse

    June 1, 2013 at 8:36 am #4342
    kuzzy
    Forum Participant

    I agree with Bob. If I had of seen them, I too would have bid, but I haven’t been on the Bay much lately due to my schedule around here. Hard to believe no one bid on them.

    Paul

    December 6, 2013 at 4:19 am #5280
    Eric Strasen
    Forum Participant

    I thought Rogers was the only maker of 2X3 tubes, although they may be branded otherwise.
    I have two N.O.S./N.I.B. examples — one Rogers and the other Philco-branded (no doubt made by Rogers). I bought them from a vendor in Florida a couple years back when I scored a Rogers-Majestic table radio on the ‘bay. I paid $25 each for the tubes.
    Turns out the ones in the radio were fine, but I’m holding on to the spares just in case…
    Eric S.

    December 7, 2013 at 8:46 am #5281
    Dan Walker
    CVRS Member

    I have a couple of Rogers radio that use those tubes and like the rest I would have bid on them. What I
    really need is a couple of Rogers 6F’7s.

    December 7, 2013 at 8:52 am #5282
    Eric Strasen
    Forum Participant

    The one Rogers spray shield tube for my Rogers-Majestic I have found to be unobtainable in working condition is the 6A7M. Fortunately, a 6A8G with a Goat shield will substitute just fine.
    Eric S.

    December 7, 2013 at 8:56 am #5283
    Eric Strasen
    Forum Participant

    Perhaps CVRS should create a forum specifically for weird Rogers tubes.
    Eric S. again

    December 8, 2013 at 8:29 am #5284
    dwhite
    Keymaster

    What about a forum called Radio Tubes to include all tube talk, and if you want we could create sub-forums for specialty items?
    Don

    December 8, 2013 at 8:59 am #5288
    Eric Strasen
    Forum Participant

    Don,
    Sounds good to me.
    A good topic for discussion might be spray shield tubes and who was first with them — Rogers or Grigsby-Grunow.
    Eric S.

    December 8, 2013 at 10:26 am #5289
    Don
    CVRS Member

    Good. I’ll do it now. I’ll create a forum in Forum Lounges called Tube Talk to cover tubes generally, then you can start any topics on tubes you wish within that forum. I’ll also move this topic (and any others on tubes already existing) to that forum. Thanks for the suggestion, Eric. Good idea!
    Don

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.