Home Forums Radio Parts Wish List NordMende Elekrta C

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #24829
    Ralph Spracklin
    Forum Participant

    NordMende Elektra “C” Looking for Set of Knobs for this radio. I am in Ontario. (Beige or Gray wth Brass Rings) This is not my radio, as shown, but it is in almost as good a condition as this one.
    Scroll down to third Picture.
    https://radioattic.com/item.htm?radio=0880103

    Ralph

    #24836
    Ralph Spracklin
    Forum Participant

    A lot of those German Radios from the 50s and early 60s had Knobs similar to the Knobs I am looking for. Radio Makers such as AEG; Telefunken; Saba; the list goes on. A set from such radios could suffice my need, even if they require a little modification. My outside Shafts, the smaller two of the four, are of small diameter, a little over 1/8 inch diameter, and use set screws to secure them. Any help would be appreciated.

    Ralph

    #24837
    Ralph Spracklin
    Forum Participant

    A lot of those German Radios from the 50s and early 60s had Knobs similar to the Knobs I am looking for. Radio Makers such as AEG; Telefunken; Saba; Lowe; Grundig; etc. the list goes on. A set from such radios could suffice my need, even if they require a little modification. My outside Shafts, the smaller two of the four, are of small diameter, a little over 1/8 inch diameter, and use set screws to secure them. Any help would be appreciated.
    https://radioattic.com/item.htm?radio=0880103

    Ralph

    #24874
    Sterling Spurrell
    CVRS Member

    Hi this work?

    #24875
    Sterling Spurrell
    CVRS Member
    #24878
    Ralph Spracklin
    Forum Participant

    Morning Sterling
    Looks like we could just have a winner here.
    What are we talking cost-wise?

    Ralph

    #24879
    Sterling Spurrell
    CVRS Member

    Just make me a offer.

    #24880
    Ralph Spracklin
    Forum Participant

    See Private Message,

    Ralph

    #24881
    Ralph Spracklin
    Forum Participant

    Many Thanks to Sterling, I found a suitable set of Knobs.

    Ralph

Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.