Thanks again Les for your help. The P-24207 electrolytic is no problem.
With the other multi-cap, I can trace the + lines ok. There are only the 3 wires coming from the can so I assume that these 3 caps are currently grounded to the can itself. If so and since I’ll be placing the new caps inside the existing can, can I run an insulated wire from the new caps -‘s to the chassis to ground them? There is no lug/ tab under the chassis on the existing can to solder too.
I know this is basic but I have trouble with multi cap electrolytics and I don’t want to mess up the polarity.